Mackie DJ Mixer Manuel d'utilisateur télécharger pdf (Page 13)

1

Owner’s Manual

Program Input Section

5. LEVEL

This knob adjusts the gain of the program input

signals selected by the position of the source select

switch [26]. This knob ranges from off to +13 dB of

gain at maximum. Adjust this with your good eye on the

program meters [43], so the level is typically bouncing

between the 0 and +6 LEDs.

. SOURCE Select

This switch selects one of three possible input sources

for the program channel:

FireWire: The signal coming in from the FireWire

interface is selected as the source.

Line/phono: The signal connected to the phono

input [3] is selected. This could be from a

turntable or from a line-level playback device,

depending on the setting of the line/phono

switch [4].

CD: The signal connected to the CD input [2] is

selected.

Using this heavy duty switch, you can have signals

coming in on all three inputs, and quickly change

from one input source to another, without the need for

repatching.

7. HIGH EQ

This knob gives you up to 10 dB of boost at 4 kHz and

above, and turns off the signal at 4 kHz and above when

the knob is turned to the kill position. At the center

position, the high EQ has no effect on the signal.

8. MID EQ

This knob gives you up to 10 dB of boost at 1 kHz, and

turns off the signal at 1 kHz when the knob is turned to

the kill position. At the center position, the mid EQ has

no effect on the signal.

9. LOW EQ

This knob gives you up to 10 dB of boost at 300 Hz

and below, and turns off the signal at 300 Hz and below

when the knob is turned to the kill position. At the cen-

ter position, the low EQ has no effect on the signal.

When all three EQ knobs are turned to the kill posi-

tion, the signal is effectively muted and no signal passes

through to the output.

0. FX

Press this switch in to send the program signal to

the FX send outputs [6]. This allows you to send the

signal to an external effects processor, or even provide

a direct feed for the program signal to another mixer.

This switch will route the program signal to the FX send

output connectors, interrupting the signal to the main

outputs. If there is no effects processor connected to the

FX send and returns, then the program signal is muted.

1. BAL

This knob works like the balance control on a home

stereo. Turning the knob to the left turns down the right

side, and turning the knob to the right turns down the

left side. When the control is in the center, the left and

right sides are equally as loud (assuming the left and

right inputs are equal loudness).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Mackie DJ Mixer Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Mackie DJ Mixer