Mackie Spike Guide de l'utilisateur télécharger pdf (Page 60)

User’s

Guide

Overdub (Direct Monitoring)

Overdubbing means adding new material to an existing recording. You will need to hear

both the input signal (Direct) as you perform, and the playback of the existing recording

from Tracktion (USB). Set the MIX knob initially to the 12:00 position, start Tracktion

playing and begin your vocal/guitar/sitar/whatev-ar performance. You should hear both

the new performance and the previous recording in equal amounts. Adjust the MIX knob

to taste.

If you are hearing an echo, you are probably monitoring your new performance via software as well

as the direct feed. In other words, the Tracktion output not only contains the previous recording, but

the new performance as well. So you hear three things: the direct new performance, the previously

recorded tracks, and the new performance after it has passed through Tracktion.

In general, you only want to monitor your new performance from one source: the direct feed, or via

software monitoring through Tracktion. If you listen to both, you will normally hear some kind of

echo because the software monitoring signal arrives a little later than the direct signal (see Latency

on page 62). This echo can be far from inspirational. So, while monitoring the direct signal, be sure

you are not monitoring through software as well. This is achieved in Tracktion by clicking the “e-to-

e” (end to end) button in the master transport section, so it is not lit. In other recording software,

it can be achieved by disabling the monitor button on the track, or muting the record track. Consult

your audio software documentation for more information.

DIR US

MIX

disable e-to-e

Lower half of Tracktion screen

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 76 77

Pas de commentaire

Mackie Spike Guide de l'utilisateur Page 60