Mackie 8Bus Manuel d'utilisateur télécharger pdf (Page 45)

D8B Manual • Chapter 2 • page 39

Transport Section

This section provides control for external recorder

transports, time display, snapshots, locates, and loops.

POSITION display

• Shows the numeric representation of SMPTE

or MIDI Time Code (Hours: Minutes: Sec-

onds: Frames) or a musically referenced

display (Bars: Beats: Ticks).

• When the console is receiving time code, this

display continually updates according to the

time code position.

• Displays entered values for Locate storage.

RANGE display

• Shows the snapshot number in Snapshot

mode.

• Shows the most recently entered MMC locate

point when in Locator mode.

• When looping it shows the beginning (FROM)

and ending (TO) locate points for the loop.

SET TIME button

• Press this button to enter a new time in the

Position Display (in Hours: Minutes: Seconds:

Frames or Bars: Beats: Ticks)

• The number buttons are used to enter the time.

• Press ENTER to complete the action. This

sends an MMC locate command.

SMPTE VIEW button

This button toggles between SMPTE/MTC time

and BBT (Bars/Beats/Ticks) in the Position display.

Number Buttons 0–9

• Used to numerically enter Snapshot, Locate,

and Loop points in the Range display, and

time values in the Position display.

• When numeric buttons are used to enter data,

you must press ENTER to complete the action.

• Pressing the number keys while holding CON-

TROL scrolls through the on-screen interface

windows.

ENTER button

• Initiates numeric changes that have been

typed into the snapshot, locate, position, or

range display from the console number but-

tons (or standard IBM-style keyboard

connected to the console).

• Pressing CONTROL and ENTER increases the

SNAPSHOT or LOCATOR selection (control

surface only).

• Pressing ALT and ENTER decreases the

SNAPSHOT or LOCATOR selection (control

surface only).

LOCATOR button

• Allows the number buttons to be used for en-

tering specific location numbers.

• Each location number (00 – 99)

may represent a specific time during

an MTC-referenced playback or re-

cording, if previously stored.

• When in this mode, the left two

digits in the Range display indicate

the locate point number.

• Locate points can be captured

while tape is moving. Simply hit

STORE, the Locate number, and then

ENTER at the instant you wish to

store a location.

LOOP button

• Used to set the start and end Locate

points in a Loop.

• To loop a segment, first enter the

locate start point using the numeric

buttons (onboard or computer key-

board), then press ENTER.

• Next, press LOOP, enter the ending

locate point number, then press ENTER.

SMPTE VIEW

SET TIME

MINUTESHOURS

SECONDS FRAMES

BARS

BEATS LOOP

TICKS

POSITION

RANGE

MODE

FROM TO

ENTER

STORE

LOCATOR

LOOP

SNAPSHOT

JOG & SHUTTLE

SHUTTLE

JOG

REWIND

FAST FWD

STOP

PLAY

RECORD

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 197 198

Commentaires sur ces manuels

Pas de commentaire

Mackie 8Bus Manuel d'utilisateur Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical supplémentaire Mackie 8Bus

Powiązane produkty i podręczniki dla Akcesoria do konsoli do gier Atomic Accessories PSPA.82