Mackie HDR24/96 Manuel d'utilisateur télécharger pdf (Page 11)

User’s Guide

Troubleshooting & Warranty Service

If you think your Remote 24 has a problem, try the following:

Make sure the cable is plugged into the “Remote” jack on the

rear panel of the HDR24/96 - the “Remote” jack is easy to

confuse with the Ethernet jack.

Remove and reinstall the cable, reboot the HDR24/96, and/or

replace the Remote 24 cable (available at computer supply

stores).

Be sure you are not using a CAT-5 crossover cable (usually

known by its yellow color and always labled “Crossover”).

Put the Remote 24 into self-test mode and test the function of

the swiches and LEDs.

• Place a blank floppy disk into the HDR24/96 and power

up the unit while holding down Record Ready buttons 1

and 2 on the Remote 24.

• When the unit is first powered on, all LEDs will be lit,

and the Remote 24 firmware version number is shown in

the Take and Track Number displays.

• Pressing a button associated with an LED turns the

LED off.

• Pressing a Locate button lights the LED above it in the

Locator section.

• Pressing the Take Select buttons increments/

decrements the Take and Track Number displays; and

pressing the Track Select buttons increments/

decrements the Meter display.

After all this, if it still doesn’t work properly please contact Mackie

Designs technical support at (800) 258-6883 (8:00 AM to 5:00 PM

Pacific Time) - see the included Warranty Card for details.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Mackie HDR24/96 Manuel d'utilisateur Page 11