Mackie TT24 Manuel du propriétaire télécharger pdf (Page 9)

Owner’s Manual

13. Press AUX SENDS 1 in the V-POT CONTROL area

(Figure 2-3).

14. Increase the Aux 1 level on channel 1 using the

V-Pot.

15. Press the AUX MSTR QuickMix button (Figure 2-

4).

16. Adjust Aux 1’s master level with its correspond-

ing QuickMix knob (see the Aux Master screen in

Figure 2-5).

You should hear your mic in the monitor speaker

attached to Aux 1.

Engage and adjust the variable high-pass

ﬁlter

17. Press HPF in the V-POT CONTROL area (Figure

2-2). This assigns the high-pass lter to the channel

V-Pots.

18. Engage the high-pass lter for channel 1 by pressing

its V-Pot knob so the bottom red LED lights.

19. Rotate the V-Pot to adjust the lter in the range

20–400 Hz to remove unwanted low frequencies.

20. To view the frequency range, select channel 1 and

press the QuickMix EQ button.

The Touchscreen now displays the HPF frequency

range.

2.3 Connect a CD/Tape Device

This section illustrates how to connect a CD/tape

device to the dedicated CD/ TAPE A or B connectors

(A = RCA, B = TRS), and to channels 23/24 to demon-

strate stereo linking and channel strip processing.

Connect CD to CD/Tape input

1. Connect the CD player into CD/TAPE A or B

(Figure 2-1).

2. Press the UTIL button (Figure 2-4).

3. Touch STEREO INPUT ASSIGN on the Touch-

screen (Figure 2-6).

4. Touch TAPE/CD A or TAPE/CD B in the INPUT

SELECTION area (Figure 2-6).

5. Select L/R in the GRP ASSIGN area to route the stereo

source to the LEFT and RIGHT MAINS outputs.

6. Adjust MUTE and SOLO from the Touchscreen.

7. Adjust the stereo input fader to desired level from

its QuickMix knob.

Connect CD to channels 23 and 24

1. Move the CD to the channel 23 and 24 LINE con-

nectors.

2. Set the LINE switch to the down position (line level).

3. Press and hold channel 23 and 24’s SELECT

switches until the Link Channels dialog appears in

the Touchscreen.

4. Touch OK to approve the channel linking.

5. Press the PAN button in the V-POT CONTROL area

(Figure 2-3).

6. Turn channel 23’s V-Pot hard left. Channel 24 auto-

matically pans in the opposite direction. Pretty cool!

7. Activate the SOLO button above the fader on either

channel to solo. Because PFL is engaged, the linked

channel does not also solo.

8. Adjust the channel’s GAIN knob and watch the

meters to the right of the Touchscreen.

The level should be between -7 and -10 dBFS.

9. Repeat steps 7 and 8 for the other channel in the

linked pair.

NOTE: Stereo linking always operates on a

consecutive odd/even channel pair. The odd

channel’s parameters are copied to the even

channel except Pan, which is inversely linked

(i.e., hard left on odd channel translates to

hard right on even channel).

Figure 2-6 Stereo Input Assign

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Mackie TT24 Manuel du propriétaire Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de DJ Mackie TT24